Setup ST Wireless to connect to other WIFI

In v2.0.3 firmware the option to connect to another wifi as a slave using static IP address.

Connecting just requires some settings setup in the setup page , if you connect to wifi using the built in AP and then go to settings (this can be seen on the standard setup page).

Settings that need setup
Wifi Slave Mode – Ticked
SSID – The ssid of the wifi to connect
Password – wifi password

Ipaddress – Static Ip address eg 10.10.10.101
Subnet – Subnet eg 255.255.255.0
Gateway – Gatway ip eg 10.10.10.1

DHCP – Ticked = Dynamic IP , though you will need to figure out the IP to connect to or see if the Host name nauti-control works.