IF you have a NMEA/ST 5 pin socket such as above on your boat then you will need to rin a wire from pin 4 (Seatalk Data) to the Middle Data Pin on the Nauti-Control box.
Positive and Negative should from same source . Handheld remote is equivelent to Nauti-Control box wiring wise.
Below you can see the wiring for the Nauti-Control Box . Ensure all power is off and that polarity is not reversed when installing.
autohelm autopilot autohelm remote Bluetooth autopilot control boat electronics ESP32 marine controller Firmware Update Marine Dashboard marine electronics marine navigation app Mobile App Update N2K N2k Wiring Nauti-Control firmware update Nauti-Control mobile app Nauti-Control N2K Wireless Nauti-Control v2.0.3 Nauti-Control v2.0.4 Nauti-Control wear app Nauti-Control Wireless V1 NMEA2000 WiFi gateway NMEA 2000 wiring OpenCPN WiFi Raymarine raymarine autopilot remote Raymarine autopilot wireless raymarine remote Raymarine SeaTalk raymarmine autopilot remote sailing technology Seatalk seatalk autopilot SeaTalk NG WiFi seatalk ng wiring Seatalk Remote SeaTalk retrofit solution Seatalk SImulator Setup short handed sailing Signal K gateway solo sailing st4000 autopilot st6000 autopilot ST Wireless wireless autopilot control wireless boat data
Leave a Reply
You must be logged in to post a comment.