Mapping Custom 433mhz Remote Codes to Nauti Control Actions

|

From Firmware 2.0.3 available for download now the setup screen has an extra section to allow custom 433mhz codes to be programmed . This allows remotes that arent pre-programmed for nauti control to be mapped .

To map the buttons you need to gather the codes by using the new debug features . When you press a button you will see a long number appear in the debug window as below

Record the number associated with the button presses you are interested in using to map . These are required to be entered on the Setup page in the custom button section below. Also ensure you have Enable radio debugging setup otherwise these codes will not display this is in the setup window shown below.

Once all is setup click save settings and you should be able to use the newly programmed remote.

You can purchase a waterproof one that has been tested (as per the video above) with Nauti-Control

Leave a Reply