This guide explains how to programme the Nauti-Control 4-button clonable remote by copying button signals from an existing compatible fixed-code remote.

The remote has four buttons, normally marked A, B, C and D. Each button can be cloned from a button on your existing working remote.

Important: This remote must be cloned from an existing compatible fixed-code remote. It is not supplied pre-programmed and will not clone rolling-code remotes.

Before You Start

• Make sure your existing remote is working correctly.
• Keep both remotes close together during cloning.
• Clone one button at a time.
• If the remote does not pick up the signal straight away, move the remotes slightly closer, further apart, or change their angle/location.

Step 1: Put The New Remote Into Learning Mode

On the new remote, press and hold buttons A and B together.

Keep holding both buttons until the light at the top of the remote starts flashing.

Once the light starts flashing, release both buttons. The remote is now ready to learn button signals.

Step 2: Choose The Button You Want To Programme

Press and hold the button on the new remote that you want to programme. This can be button A, B, C or D.

For example, if you want to programme button A on the new remote, press and hold button A.

Step 3: Copy The Button From Your Existing Remote

While holding the button on the new remote, press the button on your existing remote that you want to copy.

The light on the new remote should flash once to show that it is ready to copy the signal.

Once the new remote detects the signal from the existing remote, the light will start flashing continuously. This confirms that the button has been cloned.

Step 4: Repeat For The Other Buttons

Repeat the same process for each button you want to clone.

• Hold the button on the new remote that you want to programme.
• Press the matching button on your existing remote.
• Wait for the new remote to confirm the signal has been copied.
• Move on to the next button.

Example Button Setup

You can copy the buttons in any order you prefer. For example:

New Remote Button	Copied From Existing Remote
A	Button 1
B	Button 2
C	Button 3
D	Button 4

The exact function of each button depends on how your existing remote and Nauti-Control controller are configured.

Troubleshooting

Issue	What To Try
The new remote does not flash continuously	Move the remotes slightly closer together, further apart, or change their angle, then try again.
The new remote flashes once but does not copy	Keep holding the button on the new remote and press the button on the original remote again.
Only some buttons clone	Repeat the cloning process for each button individually.
The remote will not clone at all	Check that the original remote is a compatible fixed-code remote. Rolling-code remotes cannot be cloned.
The cloned button does not control the expected function	Check which button was copied from the original remote, then re-clone the button if needed.

After Cloning

Once the buttons have been cloned, test each button with your Nauti-Control controller.

If you need to change what a cloned button does, you can update the assigned button action in the Nauti-Control app, depending on your controller setup.